Bohrständer
Bedienungsanleitung / Operating instructions / Mode d’emploi
- 24-
02952300993
5001156-03
Note: store not mounted drill bits in a dry, high or locked place, out of the reach of children or
unauthorized persons!
Small drill bit diameter - lying position!
Large drill bit diameter - standing position!
3. Description
3.1 Technical
data
The drill rig KB500 can be provided with several drill motors
and each of them allow different drill ranges. The drill rig
equipment is only for drill motors, that are mentioned by Gölz
GmbH in the following tabulations.
Distance plates can only be used, if they are certified for the
respective application of the Gölz GmbH (see tabulation).
Select dowels, whose middle breaking load lies minimum
factor 2 over the load of the fastening point.
When dimension L2 is minimal (at the end of the slot), the
largest dowel back forces F appear with the same contact
force of the drill bit. Therefore, choose the dimension L2 as
tall as possible (Fastening point close to column).
Stroke (mm-in.):
800 - 31.5
1200 - 47.24
1800 - 70.86
2400 - 94.5
2650 - 104.33
Feed:
Manuel: with hand wheel or hand wheel with reduction gear unit
(Feed 1:1 or 1:4)
Mechanical: BorMatic 500
Angle drilling:
Cont. adjustable up to 45°
Weight:
(without handwheel
and drill motor)
ca. 39 kg
- 72.6 lbs.
ca. 44 kg
- 81.9 lbs.
ca. 52 kg
- 96.8 lbs.
ca. 57 kg
- 106.1 lbs.
ca. 60 kg
- 111.7 lbs.
Length (mm-in.):
688 - 27.1
Width (mm-in.):
(without hand
wheel)
350 - 13.78
Height (mm-in.):
1260 - 49.6
1814 - 71.42
2471 - 97.28
2911 - 114.6
3115 - 122.64
Drill area:
Up to diameter 600 mm – 23.62 in.
Accessory:
Reduction gear unit
Special form:
X
X
