Bohrständer
Bedienungsanleitung / Operating instructions / Mode d’emploi
- 27-
02952300993
5001156-03
Drill bit
4.3 Mounting the drill motor
Place the drill motor with the lower side of the
mounting plate on the axle. Slew it in (fail-safe
snaps in) and tighten the eccentric shaft. Losing the
eccentric shaft and pulling out the fail-safe, the drill
motor can be easily removed.
4.4 Mounting the drill bit
Mount the brass ring, O-ring and drill bit.
The threads must be clean and not damaged.
4.5 Adjusting the drill angle 45°
1. Loosen clamping lever and screw (1) and the screws (2) at the column acceptance.
2. Turn the column into the wanted angle position.
3. The taper (3) on the dowel shows a 45°- angle.
4. Tighten the clamping levers and the screws.
O-ring
Brass ring
SW 41
Motor
1
3
2
Fail safe
Eccentric shaft
Mounting plate
Axle