Important Notes
Page 2 (44)
at
os
2-
3_r
ev02_
so
-40
0-
800
-v7
-5
-0_en_r
ev
-b
2012
-01
-03
Important Notes
Symbols
In this user manual the following standard signal words may be
used:
This label points to a situation that might be
dangerous and could lead to serious bodily
harm or to death.
This label points to a situation that might be
dangerous and could lead to light bodily harm.
This label points to a situation in which the
product or an object in the vicinity of the product
might be damaged.
This label indicates important application notes
and other useful information.
Safety and Health Hazard Notes
•
The used laser meets laser
class 1
according to DIN EN 60
825-1 (optical output power < 0.39 mW, wavelength 650
nm).
•
Do not use equipment connected to AC power during heavy
thunderstorms. Due to voltage variations and transient vol-
tages in the low-voltage network, malfunctions and danger-
ous voltages between housing and other components may
occur.
•
In extreme positions, stands with horizontal extension arms
may fall over. Avoid such positions. Use the product only on
a safe and steady ground.
•
When measuring large objects, make sure you comply with
the respective valid accident prevention regulations.
•
Operate the equipment only with the operating voltages
printed on the housing. Using an incorrect operating voltage
may cause malfunctions or the risk of fire.
•
Artificial optical radiation (projector light). When operating,
do not look into the light source for a longer time. Directly
looking into the light source may be harmful for your eyes!
(See also 2.1.1 Technical Data).
•
Check cables and, if damaged, replace them by all means.
Protect the cables from mechanical load (squeezing, ten-
sion, etc.). Damaged cables may cause short-circuits and
the risk of fire.
•
AC power connection of the unit must comply with the valid
regulations of the respective countries.
•
Replace fuses only with components having the same spe-
cifications.
•
Never unplug or connect cables during operation!
•
The devices must not come into contact with water. For
cleaning, use a moist cloth but first disconnect the power
plug.
•
The ambient temperature must be b5 and +40 °C.
Make sure no rapid temperature variations occur that might
cause condensation.
•
The housing may only be opened when no voltage is ap-
plied.
•
Do not stick any strange objects into the housing.
•
Never cover the venting slots.
•
Never operate the sensor without the corresponding air fil-
ter, see section 10.
Legal Notes
No part of this publication may be reproduced in any form or by
any means or used to make any derivative work (such as
translations, transformations or adaptations) without the prior
written permission of GOM.
GOM reserves the right to revise this publication and to make
changes in content from time to time without obligation on the
part of GOM to provide notification of such revision or change.
GOM provides this manual without warranty of any kind, either
implied or expressed, including, but not limited, to the implied
warranties of merchantability and fitness for a particular pur-
pose.
GOM may improve or change the manual and/or the product(s)
described herein at any time.
Copyright © 2011
GOM mbH
All rights reserved!
