General
Sensor Setup
Page 16 (44)
at
os
2-
3_r
ev02_
so
-40
0-
800
-v7
-5
-0_en_r
ev
-b
2012
-01
-03
7.
Sensor Setup
7.1
General
In order to adjust the sensor, the complete system including the
ATOS software needs to be installed and the sensor must be
equipped with a set of lenses matching the measuring volume and
the camera position.
For each measuring volume (MV), the set of lenses are factory-
preadjusted.
If you have the respective set of lenses for each measuring volume,
setting up the sensor is easy as you do not need to carry out all the
steps referring to adjusting the focus and aperture!
You always need to perform a complete sensor setup if, for example,
the corresponding set of lenses has never been adjusted before or is
decalibrated.
7.2
Measuring Volume
Use the table in section 3.1 to determine a measuring volume.
You create larger measuring volumes with camera positions
400 and
800
and smaller measuring volumes with camera position
SO
(see ta-
ble 3.2).
Please check whether the cameras are in the correct position. How to
change the camera positions is described in section 7.3.
7.3
Changing the Camera Positions (Step by Step)
In order to change the camera distances, you need to open the sensor
housing. Therefore, disconnect all cables from the sensor.
It is not possible to operate the sensor without the upper part of the
housing!
In the following, we describe how to change the camera distance from
400
to
SO
.
When you are changing the distance from
SO
to
400
or when you
are changing to camera position
800
, please proceed corresponding-
ly.
