User manual
LED reading magnifier
41255
REV2019-07-05
V1.0 ss
Subject to change without notice.
Goobay
®
by Wentronic GmbH | Pillmannstraße 12
38112 Braunschweig | Germany
- 2 -
EN
Specifications
Operating voltage (V )
4,5
Number of LEDs
3
Light colour
warm white
Power consumption (W)
0.24
Colour temperature (K)
~ 10000
Nominal luminous flux (lm)
16
Magnification of lens
Ø 75 mm (with 2 LEDs)
Ø 22 mm (with 1 LED)
1.75x
12.25x
Nominal lifetime (h)
25000
Protection level
IP 20
Protection class
III
Operating temperature (°C)
-5 ~ +40
Housing colour
white / black
Dimensions (Ø x l ) [cm]
8,3 x 19,1
Net weight (g)
120
Batteries
(not included in the scope of delivery)
Type
Voltage (V )
alkaline battery, AAA (micro)
1.5
Quantity (pcs.)
3
1 Safety Instructions
1.1 General
•
Read the user manual completely and carefully before use.
The user manual is part of the product and contains important information for
correct use.
•
Keep this user manual.
The user manual must be available for uncertainties and passing the product.
•
Do not modify product and accessories.
•
Do not open the housing.
•
Use product, product parts and accessories only in perfect condition.
•
In case of questions, defects, mechanical damage, trouble and other
problems, non-recoverable by the documentation, contact your dealer or
producer.
Not meant for children. The product is not a toy!
•
Secure packaging, small parts and insulation against accidental use.
• Never leave the LED reading magnifier unattended.
Risk of blindness
Never look into the sun or other strong light sources with the LED reading
magnifier, not even close to them.
There is a danger of blindness!
•
Never look directly into the light sources of the LED reading magnifier.
The eyes can be damaged!
Fire hazard
•
Do not leave the LED reading magnifier in the sun.
There is a risk of fire due to bundled light beams and concentrated heat.
Risk of injury by stumbling and falling
•
Do not use the magnifying glass when you are moving.
Obstacles can be overlooked and get tripped over it.
•
Handle the product carefully.
It can be damaged by shocks, blows or falling from a low height.
•
Do not touch the lenses with your fingers, fingernails and/or sharp/pointed
objects.
•
Avoid stresses such as heat and cold, moisture and direct sunlight
vibration and mechanical pressure.
1.2 Batteries hazards
•
Do not mix old and new batteries.
•
Only use batteries of the same or equivalent type as recom mended.
•
Do not mix alkaline, carbon zinc or nickel cadmium batteries
.
•
Remove leaked, deformed or corroded batteries from the product and
dispose them by appropriate protectives.
•
Do not throw into fire.
2 Description and Function
2.1 Product
The LED reading magnifier is ideal for displaying fine details such as extremely
small fonts, pictures, objects in books, newspapers, cards, elektronics, jewellery
etc.
•
with pleasant grip for good handling.
2.2 Scope of delivery
LED reading magnifier, user manual
2.3 Operating elements and product parts
1 Large Lens
2 Small lens
3 On/Off button
4 Grip
5 Battery comparment
6 LED
3 Intended Use
We do not permit using the device in other ways like described in
chapter „Description and Function“ or „Safety Instructions“. Use the
product only in dry interior rooms. Not attending to these regulations
and safety instructions might cause fatal accidents, injuries, and dama-
ges to persons and property.
4 Insert batteries
NOTICE! Material damage due to incorrect power supply.
•
Only use batteries specified in the chapter „Specifications“ or batteries of
an equivalent type.
•
Observe the safety instructions in chapter „1.2 Battery hazards“.
1. Check the scope of delivery for completeness and integrity.
2. Open the battery compartment (5) on the back of the LED reading magni-
fier handle. See Fig. 2a.)
3. Insert 3 new batteries into the battery compartment, observing the polari-
ty of plus and minus. Fig. 3b).
4. Make sure that the the strap to remove the batteries is between the lowest
and the two batte ries above.
5. Close the battery compartment with the battery cover. Fig. 3c).
6. Let it click into place with an audible click.
5 Switching lighting on / off
1. Switching on: press the on/off button (3) 1x briefly.
2. Switching off: press the on/off button once again briefly.
6 Replacing the batteries
If the luminous power of the LEDs becomes weaker or if the LED reading magnifier
cannot be switched on any more, the batteries must be replaced.
7 Replacing light sources
The light sources are not exchangeable.
8 Maintenance, Care, Storage and Transport
•
Only use a dry and soft cloth for cleaning.
•
Do not use detergents or chemicals.
• Store cool and dry.
•
Remove batteries / rechargeable batteries when not in use.
• Store the product out of the reach of children and in a dry and dust-pro-
tected ambience when not in use.
•
Keep and use the original packaging for transport.
9 Disposal Instructions
9.1 Product
According to the European WEEE directive, electrical and electronic
equipment must not be disposed with consumers waste. Its components
must be recycled or disposed apart from each other. Otherwise contami-
native and hazardous substances can damage the health and pollute the
environment.
As a consumer, you are committed by law to dispose electrical and elect-
ronic devices to the producer, the dealer, or public collecting points at the
end of the devices lifetime for free. Particulars are regulated in national
right. The symbol on the product, in the user manual,or at the packaging
alludes to these terms. With this kind of waste separation, application,
and waste disposal of used devices you achieve an important share to
environmental protection.
WEEE No: 82898622
9.2 Packaging
Packaging can be disposed of free of charge at the suitable collection
points – paper belongs in paper bins, plastics belong in yellow sacks and
glass belongs in used glass bins. DE4535302615620-V
10 EU Declaration of Conformity
With the CE sign Goobay®, a registered trademark of the
Wentronic GmbH ensures, that the product is conformed to the basic
European standards and directives.
