®
wentronic Electronic Components Handels GmbH hereby declares that Article No. 51501/51502 complies with the basic requirements and other relevant regulations of directives 89/336/EWG
and 73/23/EWG.
Wall-mounting
• Secure the gooseneck stand on the wall using the mounting items provided.
Should the supplied screws and plugs not be suitable for your wall, please use others.
• Put the antenna on the gooseneck stand. Using a tightening screw on the back of the antenna, the antenna is fastened to the
gooseneckstand.
Mast-mounting
• Only use a suitable mast that has been installed according to the applicable safety regulations.
• Put the antenna on the gooseneck stand. Using a tightening screw on the back of the antenna, the antenna is fastened to the
gooseneckstand.
• Fasten the antenna to the mast with the both fastening plugs and the wing nuts (see picture on mast fastening).
Two power supply possibilities
- 1. Via the 5 V antenna voltage of the DVB-T receiver
- 2. Via the 9 VDC socket power inserter with incl. power supply (#51501 DVB-T DOA 50 PS, only)
Connenction and Application
1. Voltage supply via 5 V antenna voltage of the DVB-T receiver (fi g.1)
When connecting this way, make sure that your DVB-T equipment supplies the required 5 V antenna voltage and is turned on. For
this please refer to the instructions manual of your DVB-T device.
The supplied power unit and the power adapter are not needed for this connection method.
• Connect the external DVB-T antenna to the antenna input of your DVB-T equipment.
• Plug in the coaxial plug to the antenna input of your DVB-T equipment.
• By turning manually, fasten the F plug of the antenna cable to the external antenna.
• Slide the weather proof sleeve of the aerial lead over the F plug.
2. Voltage supply via supplied power supply (#51501 DVB-T DOA 50 PS, only) (fi g. 2)
Use the power unit and the power adapter when more than one DVB-T device is using the antenna. When using this connection
method, make sure that the antenna voltage is turned off in all the connected DVB-T devices. For this please refer to the instruction
manuals of your DVB-T devices.
• Connect the antenna input of your DVB-T device to the „Receiver“ port of the power adapter. For this, use the short coaxial cable
(Coaxial plug to coaxial socket).
• Plug in the coaxial plug of the supplied aerial lead (Coaxial plug to F plug) to the power adapter („Antenna“ input).
• Fasten the F plug of the antenna cable to the external antenna by turning manually.
• Slide the weather proof sleeve of the aerial lead over the F plug.
• Plug in the low-voltage plug of the supplied power unit to the low-voltage socket on the side of the power adapter.
• Plug the power unit into a wall outlet of the public power supply grid.
fi g.1
fi g.2
Instruction manual
DVB-T DOA 50 PS
Active DVB-T external a powersupply
DVB-T DOA-57
Active DVB-T external antenna
