2
ASSEMBLY INSTRUCTIONS
1a
1b
2
3
5
4
1a. Before installation, Use the Long Machine
Screws (BB) and insert into the holes of the
adjustable mounting strap (AA).
1b. Pull supply wires out of the j-box. Attach
the adjustable mounting strap (AA) to the
electrical box with the 2 included box screws
(CC). Tighten center bracket locking screw.
Position the fixture wall plate (B) over the long
mounting screws (BB) and verify the screws
protrude through the holes long enough so
screw cap nuts (EE) will tighten fixture to wall.
Remove fixture and adjust screw length as
necessary.
2. Fixture must be properly grounded. Ground
wires are usually either green or bare copper.
Connect the fixture ground wire to the ground
wire from the J-box using a wire nut (DD).
Connect the black supply lead to the black
fixture wire; and the white supply lead to
the white fixture wire using wire nuts (DD).
Securely attach the wire nuts properly to
prevent the wires from coming loose. Push
excess wire back into the J-box.
3. Attach the provided Hex nuts (FF) to the
Long machine screws (BB) previously installed
on the adjustable mounting strap (AA) and
tighten to keep in place. Line up wall plate
(B) to installed screws (BB) on the adjustable
mounting strap (AA) and tighten the screw cap
(EE) to secure the fixture to surface.
5. Insert the Medium Base LED bulb (included) (D) into the socket and turn
clockwise until the bulb (D) seats into place.
DO NOT
force the bulb (D).
6.
RESTORE POWER AT THE CIRCUIT BREAKER.
Turn on the wall switch.
4. Use silicone adhesive caulking (not included) to seal the gap between the wall plate
and the mounting surface to prevent water seepage into the j-box.
AA
AA
CC
DD
D
BB
FF
BB
B
EE
AA
