P.4
GB
1 - User Code Programmation.
It is possible to save up to 16 user codes max.
Codes must have 5 digits.
In order to set a new code, press and hold simultaneously the [
*
]
and [
#
] keys for 3 seconds (The red LED starts blinking).
You have then 10 seconds to enter the code wanted. The correct
programmation will be confirmed by a single "beep".
If 3 short "beep" occurs then this means the memory is full / code
already exists.
2 - Operate Keypad.
Type the 5 digit code.
Each digit will be confirmed with a "beep" and a red light flashing.
Once the 5 digit code done you will hear a 1 second "beep" and
the light will flash once quickly. Then the motor will go into action.
N.B.
To pair the keypad with the motor, please follow instructions on the
instruction manual from the garage door opener as if this device was
a simple radio control.
3 - Deleting codes.
In order to delete all the codes , remove the batteries and press the [ * ]
key , insert the batteries keeping the [ * ] key pressed for 10 seconds,
you will hear 2 long “Beeps” . In case of mantainance work resetting
the radio receiver is the best thing to do .
Notes.
Pressing the # or the [ * ] key will activate the backlight for 4 seconds .
