Connecting to AC power source
Ensure all the cable are disconnected with main unit before connect to AC power source by AC power cable.
Read through the instructions before connecting other equipment.
Main unit
AC power cable
NOTE:
Before connect to AC
power, push the POWER
ON/OFF switch to OFF.
8
BACK VIEW
SIDE VIEW
To power
outlet
Connecting to a car adaptor
The 9V car power adaptor is designed for use with vehicles
that have a 12V, negative ground electrical system.
To the cigarette lighter socket
WARNING:
Disconnect the car power adaptor when not
in use. Not in use in 24V vehicles.
CAUTIONS:
!
Use the unit only with 9V car power adaptor, use with other car
power adaptor could damage the unit.
!
!
!
!
!
The recommended 9V car power adaptor is for use with this
unit only. Do not use it with other equipment.
In the interests of road traffic safety, do not operate the unit or
view video software while driving a vehicle.
Make sure the unit is fastened securely to prevent from
moving about inside the vehicle in the event of an accident
When the inside of the cigarette lighter socket is dirty with
ashes or dust, the plug section may become hot due to poor
contact. Be sure to clean the cigarette lighter socket before
use.
After use, disconnect the 9V car power adaptor from both the
unit and cigarette lighter socket.
FUSE REPLACEMENT
FUSE
NOTE:
This unit works either on the battery pack supplied or the AC power: unplug the AC Power adapter from the DC input jack to work on the
battery pack (after fully charged); plugging the AC Power adapter while the battery pack is attached initiates the charging of this battery,
the charge LED indicator flashes red during charging, when the battery is fully charged the indicator steadies on. Fully charging a run-out
battery pack may take 5 hours or longer. A fully charged battery pack can endure approximately 2.5 hours of continuous DVD playback.
This playing time may vary with the surrounding environment, the volume level of the speaker and the battery condition. It is advised that
you wait 10-20 minutes before recharging the battery pack if it has turned flat during operation.
Basic connection
A BRIEF DESCRIPTION ON HOW TO REPLACE THE FUSE
1. Twist off the cover of the car adaptor
2. Take out the damaged fuse and replace it by using a new one.
3. Insert the new fuse into the socket of the car adaptor.
4. Finally twist on the cover of the car adaptor.
Note: The value of the fuse is F2.5A125V.
Connecting to lithium battery pack
