6
WIRING THE PLUG
If your receiver is fitted with a non-rewireable plug and you need to change the fuse, you will need to refit the fuse
cover. If you lose or damage the fuse cover, do not use the plug until you have replaced the cover with a new one.
Make sure you replace the fuse cover with one which is the same colour as the markings on the fuse.
If you have to change the plug because it is not suitable for your socket or it is damaged, cut off the plug and fit
another one following the wiring instructions below. Please throw away the plug you have removed, as insertion into
a mains socket could cause injury.
For your own safety, read the following instructions carefully before attempting to connect this unit to the mains.
WIRING INSTRUCTIONS
Your receiver is designed to operate on 230 to 240V AC, 50Hz current only.
Connecting it to another power source may damage the receiver.
The wires in the mains lead are coloured as follows.
Blue = Neutral Brown = Live
WARNING
To prevent electric shocks,
do not remove the cover
IMPORTANT
The colours of the wires in the mains lead from your receiver may not be the same as the coloured markings
identifying the terminals in your plug. So please follow these instructions.
Connect the blue wire to the terminal marked with the letter N or coloured black.
Connect the brown wire to the terminal marked with the letter L or coloured red.
Do not connect any wire to the other terminal on the plug.
If you use a 13 Amp (BS1363) plug, you will need a 5 Amp fuse.
If you use any other type of plug, you will also need a 5 Amp fuse either in the plug or on the distribution board.
/LYH
%URZQ
1HXWUDO
%OXH
)XVH
$
P
S
