Compact discs
Technical data
A P P E N D I X
A P P E N D I X
Troubleshooting
Cleaning the audio heads of the tape deck
No sound
No Display
Noise with radio sound
Bad sound with tapes
No recording
No CD
playback
Remote control does
not work
- No mains supply?
- Volume at minimum?
- Are headphones plugged in the headphone socket?
- Did someone press the MUTE button?
- Replug the AC Cord.
-The TV is not set to receive the output signals from the
main unit.
-Set the TV to the main unit’s input.
- Station not tuned accurately? Tune again.
- Weak FM station? Switch to mono using MODE button.
- Weak MW stations?
Move/Rotate
the MW
aerial
slowly for better reception.
-
Aerial
accurately fitted?
- Be sure playing / recording heads and tape guiding
parts are clean, see bottom of this page.
- Try another cassette.
- Cover the safety hole of the cassette with adhesive
tape.
- Correct source CD, tape, tuner, AUX selected?
- Load a CD with the label facing upwards.
- CD scratched, broken, deformed,... Try with another.
- Condensation e. g. after a transport? Wait for a while
(20-30 minutes).
- CD dirty? Wipe with a soft cloth from the center to the
outside.
- Batteries fitted the wrong way? See page 8.
- Batteries run down? Try new ones.
- An object is blocking the direct line between remote
control and the system. Max distance to the system is
4~7 m pointing to its front.
Unplug your sound system from the mains. Open the tape compartments.
After playing and recording for a time, the sound of the tape recorders may become
muffled. Then clean the heads and tape guiding parts.
Only use a soft utensil with
alcohol or a special head
cleaning liquid.
Due to the constant improval of our products, specifications are subject to change without notice.
tape guiding
parts
playing/
recording head
tape guiding
parts
20
21
GMN10040MP3
FCS
Dimensions (W x D x H)
Set :
275 x 398 x 317.5 mm
Speaker :
99 x 251 x 326.5 mm
Weight (Set + Speaker)
7.0 kg + 3.3 kg x 2
Power supply
Voltage
AC 240 V / 50 Hz
Power consumption
(
Operating)
90 Watt
Reception range
FM :
87.5 MHz ~ 108 MHz
MW
:
520 ~ 1710 kHz (522 ~1620 kHz)
3 x CD changer
Converter :
1 bit D/A,
Oversampling : 4 x
Tape
Synchro recording, High speed dubbing,
Automatic level control
Amplifier
Total Power
50 watt + 50 watt
Speakers (2 Way)
Impedance :
6 Ohm
Always...
handle your discs with care. Hold a disc with the
fingers touching the edge or the hole.
place the disc with the label facing up.
place the disc properly into the tray using the proper
guide area for 12 cm or 8 cm discs.
replace a disc in its case after playing and store it in
a vertical position.
use a soft cloth to clean a disc if necessary and wipe
from the centre to the outside.
Never ...
play a deformed, cracked, or chipped disc.
try to repair a disc with adhesive tape or glue.
close the tray with a disc slipping out of the guide
area, or two disc inside.
scratch a disc or store it in direct sunlight, high
humidity or high temperature.
use record cleaning sprays, benzine, static electricity
liquids or any other solvent, if the disc surface is soiled.
Wipe gently with a soft,damp (water only) cloth.
wipe the disc in a circular motion, since circular
scratches are likely to occur, which will cause noise
write on the disc.
move the system during playback.
Accessories
FCS
Remote control
2 Batteries
RCA Cable
Owner’s Manual
Warranty
FM aerial
MW aerial
