Fig1
Fig2
Fig3
Fig4
Use the FUNCTION switch to select RADIO.
Move the BAND SELECT SWITCH to the MW position. Turn the TUNING control to tune to the
required station(Fig5).
This set uses a ferrite rod aerial and therefore if reception of MW station is poor rotate the unit until
best reception is found.
Move the BAND SELECT SWITCH to the FM position. Turn the TUNING control to select the required
station (Fig 6) Fully extend the FM aerial and adjust its direction for best FM reception.
For reception of a FM stereo broadcast station, set the BAND SELECT SWITCH to the FM ST.
position. The
when a FM STEREO broadcast is being
received. If the FM stereo reception is noisy (large amounts of hiss) move the band select switch
to the FM position.
MW
FM
FM STEREO RECEPTION
RADIO OPERATION
FM STEREO INDICATOR LED will turn on
Fig5
Fig6
8
CLOCK SETTING
The clock can only be set when the unit is in standby.
1.
Press the PROG / C-ADJ button the display will show either 12H or 24H .(Fig1)
2.
Press CD SKIP UP or DOWN button to choose 24-hour or 12-hour time format.(Fig2)
3.
Press PROG / C-ADJ. button , the hour digits in the display will flash, then use the CD SKIP
UP or DOWN buttons to set the current hour.(Fig3)
4.
Press PROG / C-ADJ. Button , the minute digits in the display will flash, use the CD SKIP UP
or DOWN buttons to set the minutes. (Fig4)
5.
Finally press the PROG/C-ADJ. button to set the time.
