- 9 -
Preparation
For ventilation, leave a space of at least 10
cm free all around the set. To prevent any
fault and unsafe situations, please do not
place any objects on top of the set.
Use this apparatus in moderate climate.
Before Switching On
The
TV
Power Connection
IMPORTANT:
The TV set is designed to op-
erate on
230-240V AC, 50 Hz.
After unpacking, allow the TV set to reach the
ambient room temperature before you con-
nect the set to the mains.
Connections To The RF Input
Socket
9+)8+)
Connect the aerial plug to the RF input
socket located at the back of the TV.
How To Connect Other Devices
IMPORTANT:
Switch off the TV before con-
necting any external device.
Sockets for external connections are at the
back and side of the
TV.
For connection of
other devices via
scart
refer to the manuals
of the related devices.
Inserting Batteries In The Remote
Control Handset
Insert the batteries observing the correct po-
larities as shown below.
Remove the battery cover located on the
back of the handset by gently pulling up-
wards from the indicated part.
Insert two
AAA
or equivalent type batteries
inside.
Replace the battery cover.
NOTE:
Remove batteries from remote con-
trol handset when it is not to be used for a
long period.Otherwise it can be damaged
due to any leakage of batteries.
Switching The TV ON/OFF
To switch the TV on:
1-
Connect the power supply
cable
to the
system. Press On/Off switch at the rear of
the TV. Then the TV switches itself to stand-
by mode and the
blue LED on the front
panel illuminates.
2-
To switch on the TV from stand-by mode
either:
Press a digit button on the remote control so
that a programme number is selected,
or,
Press , "
-P/CH
" or "
P/CH+
" button at the
ENG-3210W-17MB11-(UK IDTV)-1558UK-(WO DVI)-CHI MEI-50072184.p65
22.07.2005, 16:52
9
