INSTALLATION
INST
ALL
A
TION
INSTALLATION
Refer to the owner’s manual of the external equipment to be connected.When connecting
external equipment, do not connect any AC power cords to wall outlets until you have completed
all the connections.
Connecting a TV aerial
Basic Connection: Connecting an aerial .
Connect your existing TV aerial to the Aerial input socket on the TV.
The Aerial input socket can be connected with the ATV/DTV Aerial.
Connect all AC power sources before turning on the
power switch at the back of the TV.
Press the
POWER
button on your remote to turn on your LCD TV.
a. After connecting an aerial to your LCD TV and connecting the mains cable to the
TV and 230VAC mains socket, turn the POWER SWITCH of rear TV on, a red light
will show on the front centre panel of the TV.
b. Press the
POWER
button, the red light will change to green and the First Time
Installation screen will show:
1. Make sure an aerial is fitted then press OK button on the remote to start
the Auto Programme Scan (APS).
2. In a short while you will see the TV programmes briefly as each channel is
received and stored in the memory. When APS is completed BBC1 will show,
press CH+/- buttons to view the other channels stored.
c.
To power off press the
POWER
button, the green light will change to red.
Press the SOURCE button and choose TV or DTV mode then press OK to select.
1
2
3
5
Insert the supplied mains cable to the mains socket located on the rear of
the TV. Connect the other end of this cable to a 3 pin mains socket.
4
Make sure the power switch
is switched of f.
Unplug from
a wall outle t
TV Aerial
Aerial/75-ohm
coaxial input
connect the supplied
mains cable to this socket.
