placed in the receive mode or idle mode, if possible. If receive mode
only is not possible then, the radio shall be passive (preferred) and/
or active scanning. In these cases, this would need to enable activity
on the communication BUS (i.e., PCIe, SDIO, USB) to ensure the
unintentional radiator circuitry is enabled. Testing laboratories may
need to add attenuation or filters depending on the signal strength of
any active beacons (if applicable) from the enabled radio(s). See
ANSI C63.4, ANSI C63.10 and ANSI C63.26 for further general
testing details.
The product under test is set into a link/association with a partnering
device, as per the normal intended use of the product. To ease
testing, the product under test is set to transmit at a high duty cycle,
such as by sending a file or streaming some media content.
