2
6.
DO NOT ABUSE THE POWER CORD AND INSPECT IT PERIODICALLY.
Never yank the power cord to disconnect it from the receptacle. Keep the power cord away from
heat, oil and sharp edges. If it is damaged, replace it.
7.
FOR FACTORY USE ONLY
This unit has noise proof circuit for factory use. If used in a home environment it may affect
surrounding electrical appliances.
4. Operation Instructions
4.1 Set up
1. Hook the dross tray to the top-plate. It is possible to set
the dross tray on 3 sides of the unit so you can position it to
suit your needs.
2. Make sure the Power Switch is in the OFF position before inserting the power cord into the power cord
inlet and plugging the other end into a power outlet.
WARNING
To prevent fire, burns, and possible serious injury or damage:
⚫
Keep the solder pot away from flammable substances and materials in the work area.
⚫
Be sure to position the solder pot on a firm metal bench. The solder pot is heavy when filled
with solder and the solder bath and surrounding area becomes very hot.
⚫
Unplug the solder pot power cord immediately if there is burnt smell or unusual heating occurs.
Do not use the solder pot again, and return it to the distributor you purchased it from.
⚫
Do not leave the solder pot unattended when it is hot as the pot and surrounding area becomes
very hot.
⚫
Do not touch any part of the unit other than the power switch or the control panel when it is
switched ON.
Top plate
WARNING
Please observe the following in order to prevent solder splashing.
The splashed solder may badly burn you. Please be careful.
・
Do not let the spatula get wet.
Steam is generated when a wet spatula contacts the molten solder. This may
cause solder to splash.
・
Please use only the bundled spatula when you would like to
remove oxide.
Anything used in place of the spatula (Spoon,etc.) may cause solder to splash.
The spatula has unique features which cannot be substituted.
・
Spatula surface must be clear and smooth.
Anything adhering to the spatula may cause solder to splash.
・
If spatula has rust, please replace it with a new one.
