PROGRAM MODE
Overview (Software Version R2.0)
Program Mode is used to control and adjust all of the features on the Q2 and iQ2 series
G-Force®. Before entering Program Mode, review the
Program Mode Menu outline,
Chart D, pages 30-35.
Note:
An alternative to using Programming Mode via the Handle is the HMI
Visualization which can be accessed via a PC with a VNC Viewer installed.
See Appendix 2 for more info.
Using Program Mode
Program Mode is initiated by following the steps below. Reference
diagrams B
and
C
on page 26 for button locations.
Entering Program Mode (chart A, page
31
):
1.
Press and Hold
the MENU button (right-hand side of handle) for two
seconds to activate Program Mode.
2.
After two seconds, release the MENU button. The LED will illuminate amber
and “PROGRAM MODE” will be displayed for one second.
3.
Press the MENU button to toggle between menus. The OLED will display the
corresponding programmable menus:
•
V-LIMITS MENU - Virtual Limits menu
•
SPEED MENU - Lift Speed adjustment
•
RESPONSE MENU - Lift Response (acceleration) adjustment
•
SETTINGS MENU - Programmable Features on both the Q2 and iQ2 units
•
ADVANCED SETTINGS - Programmable Features on iQ2 units only
•
LANGUAGE SELECTION -– Select regional language for OLED display.
4.
Once you have reached the menu you would like to enter, press the G-Force® logo
button.
5.
The first programmable feature in that menu will be displayed. See
Chart D
,
beginning on page 34 for the full list of menus and the programmable
features under each menu.
6.
To move to the second programmable feature, press the G-Force® MENU button again.
7.
Note:
If the MENU button is repetitively pressed in a submenu, then the
selection is cleared and the last submenu option displays “RETURN BACK
TO MAIN MENU” which can be selected to navigate to the program main
menu.
8.
Once the desired feature is selected the display shows “SELECTION CONFIRMED”.
9.
After the command is executed, the system returns to standard operation, and
the OLED displays “G-FORCE READY TO LIFT”.
Entering Program Mode (
chart A
, page 27):
e
28
