Gorenje FN6192O, Instruction Manual

460401

•  Install the appliance in a dry and well ventilated room. The 

appliance will operate correctly if the environment temperature 
is in the interval speci

fi

 ed in the table. The appliance class is 

indicated on the rating plate / label with the basic information 
on the appliance.

Class

Temperature

SN (subnormal)

from +10°C to +32°C

N (normal)

from +16°C to +32°C

ST (subtropical)

from +16°C to +38°C

T (tropical)

from +16°C to +43°C

Warning

: Make sure the room where the appliance is installed is 

large enough. There should be at least 1 m

3

 of space per 

8 grams of refrigerant. Amount of refrigerant is stated on the 
rating plate in the appliance interior.

Appliance installation should be carried out by at least two 

persons to avoid any physical injury or damage to the appliance.

•   The appliance must stand level or tilted slightly to the back, 

stable on a solid base. At the front, the appliance is 

fi

 tted with 

two adjustable legs that can be used to level the appliance. At 
the rear side, casters allow for easier installation of the 
appliance (only with some models).

•  There should be a clearance of at least 5 cm between the 

appliance and any cupboard installed above it, in order to 
allow adequate cooling of the condenser unit.

•  The appliance is supplied with two spacers which should 

be installed on the lower part of the housing to prevent from 
pushing the appliance too close to the wall. Appliance may 
also be installed without the spacers; however, this may 
increase power consumption.

•  Do not expose the appliance to direct sunlight and do not 

place it near any source of heat. If this cannot be avoided, 
install an insulation panel.

Selecting the room

Installing the appliance

7

Installation and connection