15
CHANGING THE DIRECTION OF
DOOR OPENING
514083
VERSION I – CONTROLS IN THE APPLIANCE INTERIOR
Tools required: socket wrench No. 8, Phillips screwdriver, torx 25, flat screwdriver
The procedure to change the direction of door opening should be carried out by at least
two persons.
1.
Remove the upper hinge cover (A) and the covering cap (G).
2.
Undo the upper hinge (B) and remove the door (C) from the lower hinge (D).
3.
Tilt the appliance backwards (make sure you do not press against the condenser unit
on the rear wall of the appliance as this may damage the cooling system), unscrew the
lower hinge (D) and the foot (E), and move them to the opposite side. Make sure the
washer is installed like it was before disassembly.
4.
Move the door hinges (F) to the opposite side and replace the door (C) back on the
lower hinge (D).
5.
Use the screws to attach the upper hinge (B) on the opposite side.
6.
Replace the upper hinge cover (A) and the covering cap (G) on the opposite side.
7.
Replacing the handle (H): remove the handle covering caps, undo the screws, and
remove the handle. Remove the hole plugs on the opposite side of the door and attach
the handle.
Replace the covering caps on the handle. Insert the new hole plugs supplied in the bag
with the instruction manual into the holes where the handle was initially attached.
Summary of Contents for FS600 ADVANCED
