Gorenje GDF67088, Instructions For Use Manual

476452

• The 

condenser 

unit mounted on the (exterior) back wall 

should always be kept clean, free of dust or similar deposits. 
Occasionally clean the dust using a soft non-metal brush or a 
vacuum cleaner.

•  After cleaning, switch on the appliance and put the food back 

in.

13

Problem:

Cause or remedy:

After connecting to the power 
mains, the appliance does not 
operate:

•  Make sure the wall outlet is powered and that the appliance 

is plugged in.

Cooling system has been 
working continuously for a long 
period of time:

• Too high environment temperature.
• Door is open too often or it is left open too long.
• Door is not closed appropriately (there may be dirt between 

the door and the refrigerator, the door may be tilted, the seal 
should be checked, etc.).

• Too much fresh food was inserted.
• Insuf

fi

 cient compressor and condenser cooling. Check the air 

circulation behind the appliance and clean the condenser.

Ice accumulation in the freezer 
interior is a result of:

• Poor door sealing. If the seal is dirty or damaged, clean or 

replace it.

• Door is opened too often or left open too long.
• Placing warm food into the freezer.

Signal light 

D

 is on/is 

fl

 ashing:

• Frequent opening of the door, door open too long.
• Door not closed properly (particle between door gasket, 

sagged door, damaged gasket, etc...).

• Excessively long power failure.
• Excessive quantity of fresh food inserted at once.

Door won’t open easily:

• If you wish to open freezer door immediately or shortly after 

closing it, you may feel rather strong resistance. When the 
freezer door is opened, some cool air escapes from the 
freezer compartment and it is replaced by warm air from the 
environment. When this air is cooled, a sub-pressure builds 
up, causing resistance to door opening. After a few minutes, 
the condition is normalized and the door can be easily 
opened again.

Occurrence of murmur after 
closing the door:

•  After closing the door, some murmur can occur. This 

phenomenon is normal and is due to pressure equalisation

.

If none of the above reasons seems to match your problem, please contact the nearest service 
center and state the type, model and serial number as indicated on the label with basic information 
attached in the appliance interior.

Troubleshooting