Instructions for Use, Building- in and Connecting
6
Ignition and operation of burners
Gas burners may be
ignited with the electric
ignition device, built-in
adjacent to each burner.
•
To switch the gas
burner on press the
relevant cooking
control button, and turn
it to the large flame
symbol position .
•
Press the knob
towards the control
panel and turn it to the
large flame position
. Press the ignition knob a few times - (some
models only) (or use a match), until the burner
lights.
•
Once the gas starts burning, keep the control
button pressed for about 10 seconds, until the
flame becomes constant.
•
Release the button and set the desired power,
between the highest and the lowest position.
•
Setting between the zero dot and the
largest flame symbol is not recommended,
since the flame is not stable in that range, and
may easily get extinct.
•
In case the flame goes out repeat the
procedure.
•
Burner is switched off by turning the control
button to the right in the zero position (black
dot).
gas faucet is closed
maximum power
minimum power
To ensure safe use of small
diameter dishes, place the supplied extra wire
grid upon the auxiliary burner if necessary.
Cookware
Selection of the adequate dish size ensures
optimized cooking time and consumption of gas.
Diameter of the dish is of utmost importance.
The flame reaching over the edge of the
small
diameter dish
may destroy the dish, while the
consumption of gas is increased.
Gas needs oxigen for burning. In case of
excessively large dish diameter
the oxigen
supply is insufficient, consequently reducing the
burning capacity.
The wire grid
(certain models only)
The wire grid is used for dishes with small
diameter. Place the grid over the auxiliary burner
crown.
Burner type
Dish diameter
Double
220-260 mm
Large
220-260 mm
Normal
180-220 mm
Auxiliary
120-180 mm
