Action
Possible causes
Problem
Check that the salt compart-
ment lid is properly tightened.
Otherwise contact your nearest
service centre.
The water softener is leaking
salt.
Wash crystal at a low temperat-
ure and with a conservative
amount of detergent. Contact
the detergent manufacturer.
Too high temperature and/or
too much detergent can cause
etching on crystal. Unfortu-
nately, this cannot be repaired,
only prevented.
Reduce the dosage. See the
chapter
. If you have
very soft water, you may want
to dilute the rinse aid 50:50 with
water.
Rinse aid dosage setting too
high.
The dishes have a sticky
white/blue film.
Use a detergent with a bleach-
ing agent.
Lipstick and tea can be difficult
to wash off.
Spots left after washing.
The detergent compartment
must be dry when adding deter-
gent.
The detergent compartment
was damp when adding deter-
gent.
Detergent residue in the deter-
gent compartment after dish-
washing.
Check that the dishes are not
preventing the detergent com-
partment from opening.
The detergent compartment has
been blocked.
Check that the dishes are
placed securely. Spin the spray
arms to make sure they can ro-
tate.
The dishes are not correctly
placed or the spray arms are not
rotating.
Rattling sound when dishwash-
ing.
No action. The program time is
stored and next time the pro-
gram is run the corrected time
will be displayed.
The program is taking longer
than estimated.
1 minute is shown for a longer
period in the display.
Clean the coarse and fine filters.
The filters are clogged.
Water remains in the dishwash-
er.
Check that the filters are fitted
correctly. See the chapter
.
The filters are not fitted cor-
rectly.
Clean the drainage pump. See
the chapter
.
Debris in the drainage pump.
Check that the yellow drainage
pump stop on the right in the
bottom drain is in place. See the
chapter
.
Drainage pump stop missing.
Check that the hose is free from
kinks and sharp bends.
Kink in drainage hose.
35