Gorgon G303, Operation Manual

0

Gorgon G3O3

- turn the ignition on;
- press and hold the “VALET” button for at least 3 seconds;
- press the remote’s button “2”;
- release the “VALET” button.
The transfer of the system to the maintenance mode will be reported a  by dim green light of the LED 

with ignition turned on. With ignition turned off the LED will be put out.

To exit this mode simply press any button of the remote control unit.

MANUAL PROGRAMMING OF THE SYSTEM

Some of the system’s settings can be adjusted in a service (secondary) mode of programming.
Eight levels of programming are envisaged by the system, each of them having several sublevels. 

The sublevels are denoted by a combination of two digits the first of which corresponds to the number of 
a level and the second one to the number of a sublevel.

There are two methods to enter the mode of programming.

Method one:

- disarm a car (see “Disarming the System” clause);
- open and the close the door;
- with the engine turned off press and hold the button “VALET”. The LED must light with green.
- holding the “VALET” button, press the remote’s button “2”;
- release button “VALET”.

Alternative:

- enter a secret code (see “System Control Over a Secret Code”);
The transfer of the system to the mode of programming is reported by frequent LED red and green 

flashes whereupon the indicator goes down.

Press the “VALET” button a corresponding number of times to choose the required level of program-

ming. The interval between the pressings should not exceed 1 second. Each pressing is reported  by a 
green flash of the LED. Upon accomplishment of code dialing the system will confirm the entered number 
by the LED’s red flashes. Then the LED produces a green flash; this corresponds to the first sublevel on a 
chosen level, and after this the light is set according to the current meaning on the given sublevel.

On most of sublevels the setting allows or prohibits the performance of a certain function. At this a 

green LED’s lights means that the given function is allowed and the red light means that it is prohibited. 
The setting can be changed by remote’s buttons pressing: button “1” allows performance of the function, 
button  “2”  –  prohibits.  During  pressing  the  “VALET”  button  and  holding  it  until  frequent  LED’s  red  and 
green flashes the system stores a current setting to its memory and proceeds to the next sublevel of a 
chosen level. LED will indicate the number of a new sublevel by green flashes whereupon its light will be 
set in accordance with its current meaning.

If this didn’t happen and the LED turned off, then it means that all sublevels have been used and the 

system is waiting for entering of the number of a new level.

To exit this mode at any sublevel simply turn the ignition on.