Gorgon G303, Operation Manual

Gorgon G3O3

has been opened, the system arms temporally deactivated switches again. But if the hood or trunk were 
opened the system will wait until they are closed and then will start a new 10 seconds countdown.

DISTANT RADIO ALERT CHANNEL

The system has the channel of control over the pager’s radio transmitter and can generate the fol-

lowing control signals:

- arming signal;
- disarming signal;
- signal of control over the pager’s radio channel;
- warning signal (activation of the shock or volume sensor’s warning level);
- alarm signal;
Generation of each of these signals can be allowed or prohibited during the system programming 

(sublevels 6.1 – 6.6).

Radio channel control signal is sent 4 minutes upon the system arming. Signal duration is 5 seconds. 

If the system has been transferred to the alarm mode before the radio channel control signal was gener-
ated then there will be no control over the pager’s radio channel. The system does not control the status 
of shock and volume sensors during radio channel control signal generation.

The radio alert channel can be reassigned to the timer channel #3 (sublevel 6.1). In this mode the 

signal of the timer channel #3 can be generated in the following cases:

- during disarming (sublevel 6.4);
- during arming (sublevel 6.5);
- in alarm situation (sublevel 6.6);
The duration of the timer channel signal is set by sublevel 6.7.

SYSTEM CONTROL OVER A SECRET CODE

If the remote unit is not available or damaged the system can be operated by entering of a secret code.
When entering a secret code you have an option to switch between the following system modes:
- from armed or alert modes to disarmed mode;
- from immobilizer turned on to immobilizer turned off;
- from disarming with ignition turned off to the mode of system programming. In case of loss or failure 

of the available remotes this feature allows you to record and use new remote units.

To enter a secret code (two digits from 1 to 16 set on the second level of programming) you have to 

do the following:

- shortly press the “VALET” button the number of times equal to the first digit of a secret code. Each 

pressing of the button is reported by a green flash of the LED. The intervals between button pressings 
should not exceed 1 second;

- when the code’s first digit is entered make an interval until a red flash appears on the system LED 

thus reporting reception of the code’s first digit;

- immediately after this enter the second digit of  a secret code by pressing shortly the “VALET” button 

the required number of times with intervals not longer than 1 second. At this again each pressing will be 
followed by a green flash of the LED;

- if you have entered the code correctly the LED is blinking for 2 seconds by-turn with red and green 

lights, whereupon the necessary switching of the system mode is performed.

- if you have failed to enter a correct code the system will return to the mode in which it used to be 

before your attempt to enter a secret code.

TECHNICAL MAINTENANCE MODE

This mode is designed for placing a vehicle to the technical maintenance service. In this mode the 

vehicle is disarmed and automatic arming, immobilizer door locks controls are disabled. To turn the car 
to this mode:

- disarm a car (see “Disarming the System” clause);