IMPORTANT SAFETY INSTRUCTIONS
1.
READ ALL INSTRUCTIONS CAREFULLY BEFORE USE.
If you do not understand these instructions, need clarifi-
cation or further explanation, please call our toll free answer line for assistance at
1-800-304-1316
Monday through Friday 8:00 a.m. until 5:00 p.m. CST.
2.
Do not load cart with more than 800 lbs / 362 kg.
3.
Do not allow children to use the cart unsupervised. This Cart is not a toy.
4.
Always distribute payload evenly over surface of bed.
5.
Do not load any items on top of the panel. Lower panel when objects are to be loaded onto the bed.
6.
If any parts become damaged, broken or misplaced do not use the cart until
replacement parts can be obtained.
7.
Do not operate or use on objects that can cause damage to the pneumatic tires or tubes.
Do not inflate tires more than 30 psi.
8.
SAVE THESE INSTRUCTIONS.
ASSEMBLY INSTRUCTIONS
Your Cart requires assembly. Account for all parts and hardware before beginning assembly. If any parts are missing,
damaged or if you have questions or need additional instructions
DO NOT RETURN THIS PRODUCT TO THE
RETAILER,
call the manufacturer at
1-800-867-6763
.
Tools required for assembly: Medium size slot screwdriver, 6, 8, and 12mm open end wrench and /or two medium
adjustable wrenches.
Refer to the exploded drawing and the parts list on the following pages during assembly.
STEP 1
Assemble the REAR SUPPORT ASSEMBLY to the bed using
(4) 8 x 20mm Carriage Support Bolts, (2) 8 x 45mm Carriage Support
Bolts, and 6 - 8mm washers and lock nuts. Attach the Rear Axle
Support to the back of the bed using the (2) 8 x 45mm Carriage Support
Bolts and then attach the Left and Right Rear Axle Braces using the (4)
8 x 20mm Carriage Support Bolts. Tighten all nuts securely.
STEP 2
The front support assembly is mostly pre-
assembled at the factory. Please make sure all bolts and
nuts assembled at the factory are tight.
A. Attach the Front Axle Support to the bed of the wagon using (2) 8 x 45mm Carriage
Support Bolts, 8mm washers and lock nuts.
B. Secure the Center Front Axle Brace to the bed of the wagon using (2) 8 x 20mm
Carriage Support Bolts, 8mm washers and lock nuts.
STEP 3
Install the WHEELS in the following order.
A. Place the Wheel Spacer bushings onto the axles.
B. Place the Wheels onto the axles with the valve stem facing out.
C. Use the 12mm washers and the cotter pins to secure the wheels.
STEP 4
Attach the Pull Handle to the Front
Axle Support using the
8 x 60mm Pull Handle bolt, 8mm washer and lock nut.
