NO T-NUT
4 X 4 X 120"
T-NUT
CORNER POST
END REAR
IS HIGHER
THIS HOLE
ON THIS HOLE
NO T-NUT
ON THIS HOLE
4 X 4 X 120"
END FRONT
CORNER POST
STEP 8: ATTACHING T-NUTS TO THE END FRAME CORNER POSTS
1: THIS STEP IS CRITICAL TO BUILDING THE FORT PROPERLY. IF ANY MISTAKES ARE MADE HERE, YOU WILL NEED TO
DIS-ASSEMBLE AND THEN RE-ASSEMBLE TO MAKE YOUR CORRECTIONS.
2: MAKE SURE HOLES ARE FREE OF ANY OBSTRUCTIONS. USE A BOLT TO CLEAN OUT ANY DEBRIS.
3: LAY OUT EACH OF THE 4 X 4 X 120" END CORNER POSTS IN THE AREA YOU INTENDED ON BUILDING THE FORT
SIDE OF THE PLAY SET.
4: USE THE DIAGRAM BELOW TO CORRECTLY IDENTIFY AND ORIENT THE NECESSARY DIRECTION THE POSTS SHOULD
FACE.
5: USE A HAMMER TO SEAT THE T-NUTS AFTER INSERTING THEM INTO THE HOLES SHOWN IN THE DIAGRAM BELOW.
6: THE BARREL OF THE T-NUT SHOULD GO INTO THE HOLE FIRST. HAMMER THE T-NUT UNTIL IS FLUSH / ALMOST FLUSH
TO THE CORNER POSTS.
7: PAY CLOSE ATTENTION TO THE CORNER POSTS, MAKE SURE YOU IDENTIFY THE END REAR CORNER POST AND THE
END FRONT CORNER PORT. THE DIFFERENCE IS ONE OF THE HOLES IN THE END REAR IS PLACED HIGHER THAN THE
HOLE IN THE END FRONT CORNER POST. SEE DIAGRAM NOTES BELOW.
41
