25
English
Operating Instructions
Programmable multi-transducers SINEAX DME 424/442
1. Read first and then …
The proper and safe operation of the device
assumes that the Operating Instructions are
read
and the safety warnings given in the
various Sections
4. Physical installation
5. Electrical connections
6. Commissioning
11. Safety notes
are
observed
.
The device should only be handled by appropriately
trained personnel who are familiar with it and authorised
to work in electrical installations.
2. Scope of supply
(Figs. 1, 2 and 3)
Contents
1. Read first and then... ................................................ 25
2. Scope of supply ........................................................ 25
3. Brief description ........................................................ 25
4. Physical installation ................................................... 25
4.1 Mounting on top-hat rails .................................... 25
4.2 Fastening on a mounting surface ........................ 26
5. Electrical connections ............................................... 26
6. Commissioning .......................................................... 29
6.1 Technical data ..................................................... 30
6.2 Programming the transducer .............................. 32
6.3 Operation of the binary outputs .......................... 33
7. Reconfiguring the analogue outputs ......................... 33
7.1 Without hardware setting change ....................... 33
8. Maintenance .............................................................. 34
9. Releasing the transducer .......................................... 34
10. Dimensional drawings ............................................... 34
11. Safety notes .............................................................. 34
Transducer
(Fig. 1)
1
Operating Instructions
(Fig. 2) in three languages: German,
French, English
1
blank type label
(Fig. 3), for recording programmed settings
Fig. 1
Fig. 2
3. Brief description
The
SINEAX DME 4
multi-transducers
simultaneously
measure several variables of an electric power system and
process them to produce 2 resp. 4 analogue output signals.
2 or 4 digital outputs are available for signalling limits or
energy metering. For two of the limit outputs up to three
measurands can be logically combined.
The multi-transducers are also equipped with an
RS 232
serial interface to which a PC with the corresponding software
can be connected for programming or accessing and
executing useful ancillary functions.
The usual modes of connection, the types of measured
variables, their ratings, the transfer characteristic for each
output etc. are the main parameters that have to be
programmed.
Ancillary functions include a power system check, provision
for displaying the measured variable on a PC monitor, the
simulation of the outputs for test purposes and a facility for
printing nameplates.
4. Physical installation
The transducer can be mounted either on a top-hat rail or
directly onto a wall or mounting surface.
Note “Environmental conditions” in Section
“6.1 Technical data” when determining the place
of installation!
4.1 Mounting on top-hat rails
Simply clip the device onto the top-hat rail (EN 50 022) (see
Fig. 4).
Fig. 4. Mounting on top-hat rail 35
×
15 or 35
×
7.5 mm.
Aargauerstrasse 7
CH-5610 Wohlen/Switzerland
T41 56 618 21 11
T41 56 618 24 58
Telex 827 901 cbm ch
Camille Bauer AG
DME 424/442 B d-f-e
000 000
08.98
Betriebsanleitung
Programmierbare Multi-Messumformer
SINEAX DME 424/442
Mode d’emploi
Convertisseurs de mesure multiples
programmables SINEAX DME 424/442
Operating Instructions
Programmable multi-transducers
SINEAX DME 424/442
Fig. 3
15+ 16–
A
17+ 18–
B
19+ 20–
E
21+ 22–
F
23+ 24–
G
25+ 26–
H