Manual for WM110
Digital Wireless Audio System 2.4GHz
GOTHAM AG
Heimstrasse 27 - CH 8953 Dietikon, Tel. +41 (0) 44 840 01 44 - Fax: +41 (0) 44 744 25 22
www.gotham.ch - info@gotham.ch
Receiver:
1. Push the on/off button on the right side of the display for 2 seconds to
turn the device on and off.
2. «00» to «19» shows the channel number.
3. Push the up/down button on the left side of the display to change the channel.
4. The receiver will automatically be blocked if the up/down button is not pushed
within 5 seconds after turning on. This will be shown with a lock symbol on the display.
Push the up/down button simultaneously to deactivate the blockage
5. Display
symbol “A” means first microphone from first transmitter is connected.
Display
symbol “B” means second microphone from second transmitter is connected.
One receiver can do the connection to a maximum of 2 transmitters.
6. The receiver will automatically turn off if no connection to the transmitter could be made
within 100 seconds.
7. The strength of battery is shown on the display by bars in frame. 3 bars indicate full
power. One bar indicates low power. Only frame indicates to charge immediately.
Transmitter:
1. Push the on/off button on the right side of the display for 2 seconds to turn the device on
and off.
2. The microphone is built-in for vocal input.
3. The display shows the channel number from 00 to 19 and
“- -“ means
“waiting for connection”.
4. Push the up/down button on the left side of the display to adjust the volume
from U0 to U9.
5. Push the on/off button twice to switch on silent mode.
This will be shown by a red LED
6. The transmitter will turn off automatically, if no connection could be made to the receiver
within 100 seconds or if there is no voice input for 20 minutes.
7. The strength of battery is shown on the display by bars in frame. 3 bars indicate full
power. One bar indicates low power. Only frame indicates to charge immediately.
