11
Date/Time
Press “OK” into Date/time setting.
Use “Up” and “Down” to select the correct number for
year/month/day. Once you finish setting a number, press “OK” on the monitor to the next number.
Or, you can use “Left” and “Right” on the remote to get to the one that you want.
Press “MENU” button
on the remote
to exit date/time setting directly. If you don’t have the remote,
you have to go through all over these settings one by one and then press OK again to exit.
To save settings
After you set everything right, you should turn off the device by pressing ON/OFF button
on the
monitor
and hold it until the device switching off.
If you turn off the device by pressing the button on the switch cable, or just simply cut off the power
supply, the setting would not be saved.
FAQ
1. Why can't I turn on the computer properly?
Please make sure that the wiring is connected correctly according to Picture 5 and that the product is
powered on. If the product still cannot be turned on normally after confirming the correct operation,
please use the reset hole on the back of the main unit to restart the machine.
2. Why can't I take pictures even if I press the "camera" button?
Please check the mode status of the product. Under the video mode, you can take photos by pressing the
"Camera" button during video recording, but under the camera mode, you can only take photos by
pressing the "OK" button. You can't take photos in playback mode. Please refer to the instructions of
"Taking Pictures" under the section "Saving Pictures or Videos Using the Memory Card" for the detailed
operation, and follow the instructions in the instruction.
3. Why can't I get clear pictures?
Make sure that the LED lights work properly. Adjust the light to illuminate the object, adjust the object
distance by using the large knob on the stand, and then rotate the focus controller. If you still cannot
obtain a clear image, gently wipe the lens with a clean, dry cotton cloth or paper towel to ensure that the
lens is clean.
4. Why can't I save the settings?
After each setting is completed, you need to press and hold "Power on/off" button to switch off the
