Device Description HG G-84300ZC | English, Revision 08 | Date: 28.05.2020
8
Chapter 3 – Hardware
3
Hardware
3.1 Alignment of the Measuring Axis
Figure 2
Sketch: Measuring axis
3.2 Dimensions
Figure 3
Sketch: Dimensions of the casing (in mm) / Mounting Drill holes
3.3 Mounting
On the front plate of the Gyro two cover plates can be removed. Then two mounting
drill holes can be reached (see picture above). When the gyro is mounted, the cover
plates should be re-attached.
X
+
-
The angle measurement
for X increases when the
Gyro is rotated counter-
clockwise
Drill hole
Drill hole for M4 mounting screw
for M4
approx. 80
mounting
screw
