EN
22
NOTICE – Risk of Damage to Material and Property
■
Do not use the device for longer than 3 hours without a break and do not leave it
switched on for a prolonged period without any food.
■
Pull out the mains plug if a fault occurs during operation. Otherwise always switch off
the device first before the mains plug is pulled out of the plug socket.
■
Always pull the mains plug and never the mains cable when disconnecting the device
from the mains power. Do not pull or carry the device by the connecting cable.
■
Always place the device on a dry, even, firm and heat-resistant surface. Never place
the device on a soft surface. The ventilation openings on the bottom of the device
must not be covered. Otherwise it could overheat and be damaged.
■
Do not place the device on or next to heat sources such as hobs or ovens. Keep
naked flames, e.g. burning candles, away from the device and the connecting cable.
■
Do not expose the device to extreme temperatures, persistent moisture, direct sun-
light or impacts.
■
Make sure that the connecting cable is not squashed, bent or laid over sharp edges
and does not come into contact with hot surfaces (e.g. of the device).
■
Keep the device in a dry place at temperatures of between 0 and 40°C.
■
Never place objects on the device or the connecting cable.
■
Use only original accessories from the manufacturer in order to guarantee that there
is no interference that may prevent the device from working and to avoid possible
damage.
Before Initial Use
1.
Remove any possible films, stickers or transport protection from the device.
Never
remove the rating plate and any possible warnings!
2.
The device should be used for the first time without any food in it as it may produce
some smoke or odours due to coating residues. Allow the device to heat up on the
highest temperature setting for approx. 10 minutes without any food in it (see the
“Use” chapter).
3. Rinse all accessory parts thoroughly. Follow the instructions in the "Cleaning and
Storage" chapter to do this.
Accessories
Cooking Container
The food is prepared in the cooking container (
6
). It must be inserted in the main unit (
1
)
when the device is put into operation.
After it has been inserted, its handle can be folded down: Press the slide button (
13
) (in
the direction of the arrow which is printed on the button) and fold the handle down at the
same time.
To remove the cooking container from the main unit, fold up the handle.
Summary of Contents for 08811
Page 64: ......
