5
6
7
CLEANING & MAINTENANCE
CLEANING & MAINTENANCE
1. Press the Power switch (N) to turn the unit OFF “o”.
2. Fill the water tank (L) with 0.8 L warm water (30-40°C) and place back onto the
machine.
3. Take a mild decalcifying tablet/liquid (purchase at your local retailer) and put into
the water tank.
4. Place a large cup on the lower cup platform (K). Press the brew-button (C). Repeat
the process until you go through half of the water (approx. 0.4 L) in the water tank.
5. After 20 minutes the machine will go into Stand-By Mode, press the brew button (C)
or open the lever to activate. Run the remainder of the water through the machine.
6. Remove the water tank (L) and rinse thoroughly. Fill the water tank (L) with 0.8 L
warm water (30-40°C) and place back onto the machine.
7. Run one full tank of water through the machine to rinse.
DESCALING PROCEDURE
4
1
2
3
IMPORTANT: The company will not be held responsible for intervention
covered by a warranty for machines that are broken or do not work correctly due
to the fact that the user has not carried out the descaling procedure.
Do not interrupt the decalcification procedure until it has been completed.
WARNING: Any traces of lime scale (naturally present in the water) may seriously
compromise correct operation of the machine. The manufacturer recommend descaling
regularly, at least once a month (for high hardness water area).
1
A. Milk frothing device housing upper part
B. Frothing part
C. Frothing pin
D. Milk frothing device housing lower part
E. Inner part foaming part
A
B
C
D
E
CLEANING IF MILK FROTHING DEVICE IS BLOCKED
If you cannot prepare cappuccino or café latte because no milk frothing is
possible, please proceed Page 14. Please use following instruction to clean the
device and it parts thoroughly.
4
2
3
9
5
6
7
8
1. Pull out the frothing pin (C).
2. Remove the main frothing device.
3. Pull out frothing part of the milk frothing device housing.
4. Remove inner part of the frothing part.
5. Separate milk frothing device housing in upper and lower part.
6. Wash all parts by hand with warm water or wash by dish washer (top rack).
7. Do not remove the silicone tube. If blocked, rinse thoroughly with warm water.
9. Assemble all parts in proper order.
10. Install housing assembly onto the unit and insert frother pin correctly for proper
operation.
16
17
