User Guide
A.On/Off:
Hold down the on/off button to turn GoVision on
and the LED light indicator will turn red. GoVision will
automatically enter video recording status once the glasses
have been turned on and the red light will begin to flash. To
power off the glasses, hold down the on/off button for 3
seconds. The glasses will automatically save the video file
and shutdown.
B.Recording Video:
Power on the device by holding down
the On/off button. Once powered on the glasses automatically
enter into video recording status. To stop recording, press
the on/off button.
The LED light indicator will stop flashing and turn a solid red.
The system will automatically save video files in 10 minutes
increments. In order to ensure good sound quality, make sure
you do not block the microphone. The glasses have a 2
minute shut off when not in record mode.
C.Taking pictures:
When the glasses are powered on, stop
the video recording by pressing the on/off button. You will
know when the glasses are ready for taking photos when the
LED light indicator is illuminated solid red. Press the Camera
button once to take picture and save image. The glasses
have a 2 minute shut off if a picture is not taken with in this
time frame and a quick red light flash will occur when the
glasses power down.
a.Note:
Make sure there is adequate light when taking
pictures and the glasses are upright and stable.
D.File uploads:
Connect the GoVision Sunglasses with the
USB cable to a proper computer USB port. The glasses will be
recognized as a Removable Disk drive. All the GoVision files
can be accessed in the file folder DCIM.
a.Note:
Please allow time for your computer to discover the
glasses USB cable in the removable disk drive when looking
to view video and photo files. If the USB cable is not
identified after 2 minutes, ensure the 8pin end of the cable is
properly secured to the glasses, then remove the USB cable
and re-insert all the way into the computer.
