These instructions and the images herein are proprietary. Any unauthorized reproduction is prohibited.
F45VW-T4
Awning Bracket for Eurovan – Fits Fiamma and ARB Awnings
Page 1 of 2
GoWesty Camper Products
•
1119 Los Olivos Ave, Los Osos, CA 93402
•
888-469-3789
•
www.gowesty.com
MOUNTING BRACKET INSTALLATION
MOUNTING BRACKET INSTALLATION
MOUNTING BRACKET INSTALLATION
MOUNTING BRACKET INSTALLATION
Fitting the
Fitting the
Fitting the
Fitting the Front Bracket
Front Bracket
Front Bracket
Front Bracket to the Body
to the Body
to the Body
to the Body
1)
Hold the bracket up and mark the large, bottom hole for drilling. Hole should be centered 1¼” above lip on
front pillar. Drill a 25/64” hole.
2)
Attach rivet nut using rivet nut tool. Application of a silicone sealant in the bolt hole and around each
threading piece is recommended.
3)
Bolt on gasket and bracket.
4)
Drill pilot holes through bracket. Remove bracket and drill holes out to 25/64”.
5)
Apply silicone sealant and attach rivet nuts with rivet nut tool. Bolt on gasket and bracket to test the fit using
the 6mm x 20mm bolts (you will have to remove the brackets if installing an ARB awning).
Fitting the Rear
Fitting the Rear
Fitting the Rear
Fitting the Rear Bracket to the Body
Bracket to the Body
Bracket to the Body
Bracket to the Body
6)
Follow steps 2-5 with the rear bracket. The lower hole should be positioned as high as possible without being
affected by the bodyline (positioning the bracket too low could interfere with the slider door).
7)
From center of front bracket to center of rear bracket is measured as follows:
a.
EVC Winnebago: 96” (10’ Fiamma awning), 83” (8’ Fiamma and ARB a
EVC Winnebago: 96” (10’ Fiamma awning), 83” (8’ Fiamma and ARB a
EVC Winnebago: 96” (10’ Fiamma awning), 83” (8’ Fiamma and ARB a
EVC Winnebago: 96” (10’ Fiamma awning), 83” (8’ Fiamma and ARB awning)
wning)
wning)
wning)
b.
Eurovan MV/Hard Top: 83” (all a
Eurovan MV/Hard Top: 83” (all a
Eurovan MV/Hard Top: 83” (all a
Eurovan MV/Hard Top: 83” (all awnings)
wnings)
wnings)
wnings)
Release from Liability
Release from Liability
Release from Liability
Release from Liability
Please use your best judgment when installing your awning. These instructions are to be
used as a guideline, but remember the old adage: “Measure twice, drill once!” GoWesty
GoWesty
GoWesty
GoWesty
will not be liable for any damage to your vehicle during the installation of this
will not be liable for any damage to your vehicle during the installation of this
will not be liable for any damage to your vehicle during the installation of this
will not be liable for any damage to your vehicle during the installation of this kit.
kit.
kit.
kit. If
you are uncertain of your ability to safely perform the procedures in these instructions,
please have your awning professionally installed.
Tools Needed:
Tools Needed:
Tools Needed:
Tools Needed:
(dependent
(dependent
(dependent
(dependent on awning used)
on awning used)
on awning used)
on awning used)
•
Electric drill
•
15/64” & 25/64” bits
•
8mm &10mm wrenches
or ratchet and sockets
•
Phillips screwdriver
Contents of Kit:
Contents of Kit:
Contents of Kit:
Contents of Kit:
(6) 6mm rivet nuts
(20) 6mm flat washers
(6) 6mm x 20mm hex bolts (1) Rivet nut tool
(4) 6mm x 16mm hex bolts (2) 5mm lock nuts
(4) 6mm x 25mm hex bolts (8) 6mm Nylock nuts
(2) 5mm machine screws
(2) 5mm flat washers
(2) Rubber gaskets
(2) Mounting brackets
