5
Speed limit dial
(#3)
The speed limit dial is located on the handlebar
panel.
When the speed limit dial is set to MAX, the R8-S will
drive at approximately 15 km/hr.
When the speed limit dial is set to MIN, the R8-S will
drive at approximately 3 km/hr.
Do not change the speed limit dial setting while the
R8-S is moving.
Note:
Set the speed limit dial to
MIN:
Until you get used to driving your new R8-S, and
When driving the R8-S inside a building or in a
crowded area
High – Low Speed
mode Switch (#4)
Set the maximum speed of the scooter to HIGH or
LOW speed. Use the LOW speed mode when driving
in close and crowded areas.
Throttle control
lever (#5)
To drive: Gently squeeze the throttle control lever
(depending on whether you want to drive forward or
backward) until you reach the desired speed. Your
speed is directly proportional to the deflection of the
throttle control lever.
Note: You can squeeze one side of the throttle
control lever towards you, or you can push the other
side away from you to achieve the same effect. Use
whichever method is most comfortable for you.
To stop:
Release the throttle control lever. The R8-S
will stop gradually.
Turning buttons
(#6)
Before you turn, press the applicable indicator button.
When a turn indicator is activated, the applicable LED
will flash.
To turn off the indicator, press the button
again.
Hazard button (#7)
The Hazard button activates the hazard lights (front
and rear blinkers). To turn off the hazard lights, press
