Page 2 GPD Global®
01/18/93
SAFETY INSTRUCTIONS
•
CAUTION:
To achieve optimum production while avoiding possible damage to the equipment
requires the operator to properly adjust delay times and operating speeds both in relation to each
other and to component dimensions and properties.
•
CAUTION:
DO NOT operate the CF-10 with more than one option switch in the option select position.
Improper operation will result.
•
CAUTION:
GPD suggests an operator be present during machine operations to avoid possible
damage to the equipment.
INSTALLATION
The High-Low Track Sensors and Single Feed Selection options are factory installed on the CF-10.
PART IDENTIFICATION
Most of the CF-10 option controls are located on
the machine's left cabinet panel. Refer to the
figure at right for an illustrated example of these
controls.
SINGLE FEED SELECTION
CONTROLS
CF-10
When
all
option switches are in the "CF-10"
position, the options are disabled and the
CF-10 operates in its standard manner.
SINGLE FEED
When the single feed selection switch is in
the SINGLE FEED position, the single feed option is selected.
CAUTION:
DO NOT operate the CF-10 with more than one option switch in the option select position.
Improper operation will result.
VIBRATORY BOWL SELECTION CONTROLS
TRACK FULL DELAY
The TRACK FULL DELAY control knob regulates the amount of delay time between the occurrence
of a track full condition and the vibratory bowl being shut off. Increasing the TRACK FULL DELAY
setting increases the delay time between a track full condition and the machine stopping.
FULL TRACK SENSOR
The FULL TRACK sensor is located at the in-line feeder track entrance, while its adjustment control is
found under the EXTERNAL DEVICE SELECTION label (refer to above figure).
When a track full condition occurs, a delay for the amount of time set with the TRACK FULL DELAY
occurs; the vibratory bowl stops; components continue feeding into the CF-10 decreasing the track's
Summary of Contents for cf-10
Page 7: ......
