GPI Sports & Fitness TREADMILL 201 - Journey, Owner'S Manual

6.  MAINTENANCE 

1. When running belt is off the center, stop the treadmill 

immediately, use Allen Wrench to adjust the hex head 

screw. For example, the running belt is offset to the left it 

should adjust 1/4 circle clockwise; if the running belt is 

offset to the right, adjust 1/4 circle counterclockwise. 

After adjustment, start the treadmill again, if the running 

belt still off the center, repeat the adjusting procedure till 

the running belt is in the center position. 

    (Ps.1. The action is quite important, please follow the 

steps above to deal in the case of it happens.) 

    (Ps.2. The off center issue is happened sometime when 

differ user is using the unit in normal condition. Just be 

careful the running belt is not wear out the side rail. 

2. It is strongly suggested to follow the Table (in below) to 

apply lubrication on running deck. Please use 6mm 

wrench to loosen bolts in rear adjusting boxes. Pull up 

the running belt and apply lubrication evenly on the 

center of the running deck, then adjust the belt to the 

center of deck, follow by tighten the screw to the 

original set up. 

    (Ps. When the belt is sliding, please follow the adjusted 

method.) 

Speed Interval 

1~6 km 

1 year 

6~13 km 

6 months