GPI Sports & Fitness TREADMILL 304, Owner'S Manual

- 6 - 

5.

ASSEMBLY STEPS

Two persons are required to finish the assembly 

steps. 

(Caution!! Please follow the assembly 

procedure below to avoid injury. ) 

1.

Attach the control wire-lower section from 

the Frame (B) to the guide thread from the   

right Upright (D), then pull the control 

wire into the Upright , clip it with 

protecting ring and fasten it inside of the 

Upright. (As shown in the circle of the 

picture.) 

2.

After finish above steps, put the right and 

left Upright (C

、

D) on the Frame. Secure 

with Allen Bolt (a) and Washer (h). (As 

shown in the picture) 

Ps.1. To avoid unexpected accidents, assemble 

the treadmill with one or two assistants. 

Ps.2

During assembling the support tubes, one 

person is needed to hold the support tube to 

avoid the falling of the support tube. 

3.

After the Uprights are tightened, pull out 

the Control Wires which have been 

threaded into the Upright to the month of 

the Uprights. Then put Computer 

Console on the Uprights and connect the 

control wire of the Frame with the 

control wire of Computer Console (A). 

After connecting, tighten them with 

Allen Bolt (c) shown in right drawing. 

Ps.1. To avoid unexpected accident, always 

assemble the treadmill with an assistant, do 

not assemble by oneself. 

Ps.2. When tighten the screws, make sure not to 

damage the control wires in the tube. 

A

C

D

c

c