Operation of the system
Installing the GPS Buddy AT-S
Place the AT-S with the magnetic side in or on the
material/machine. We recommend installing the
AT-S in such a way that the reception of an GPS
signal is guaranteed.
Using the GPS Buddy AT-S
If a yellow and blue lamp are on on the AT-S,
the system is fully operational. The vehicle, the
material or the machines can be followed via the
planner app or the GPS Buddy Studio environment.
environment is followed. The location is establis-
hed once a day (for three minutes).
LED-status
description
Yellow lamp is on
GPRS is operational
Yellow lamp blinks for 2 sec Mobile initialisation
Yellow lamp is off
Mobile is in sleep mode
Blue lamp is on
GPS is operational
Blue lamp is blinking
look for GPS signal
Blue lamp is off
GPS is in sleep mode
Red lamp is off
System functions properly
2/4
3/4
• All equipment using Wi-Fi causes interfe-
rence. This can have a distorting
effect on other equipment.
• The equipment is splatter-proof.
• GPS Buddy is not liable for any interruption
in the electronic circuit of the material or
machine the asset tracker is attached to.
• If you notice an interruption in the elec-
tronic circuit, immediately disassemble
the asset tracker and call our helpdesk for
further instructions.
Introduction
Please note
2/4
