Chapter 1 Welcome to Use It
1.1 About the Product
Welcome to use the GW2000 watch GPS Tracker. This exquisite watch is designed for
the elderly/children positioning and guarding, businessmen safety precautions and field
personnel management. At the same time, it is available with GPS/GPRS function and
GSM/SMS/GPRS communication with a quick signal receiving speed.
1.2 Safety Considerations
To ensure your safety, please read the following Safety Considerations carefully
：
1.2.1 Storage Considerations
Don’t put this product directly in the sun or in a dusty place or pile it with other electronic
products for fear of damage. Keep it off the equipments with strong electromagnetic radiation
or a strong magnetic field as far as possible.
Don’t put its batteries, terminal or charger in a microwave oven or a high-pressure device for
fear of such accidents as circuit damage or fire.
Don’t put the terminal on an uneven or unsteady table for fear of malfunction or damage if it
drops on the ground.
Keep the product off dampness and water.
1.2.2 Batteries Operating Instructions
When the product is first used, please use up the battery power and charge the battery for 2-3
times for not less than 12 hours each time, so as to ensure the battery in good condition.
Please charge the battery with the charger provided by our company. All damages due to the
use of any other charger are on the user’ s account.
Don’t drop the batteries in fire for fear of burning or explosion of the batteries.
Don’t put any stress on the batteries during battery installation, or the batteries will be subject
to leakage, overheat, cracking or burning.
Don’t dismantle or refit the batteries for fear of leakage, overheat, cracking or burning.
Don’t use or store batteries in a hot place, such as by the fire or a heater, for fear of leakage,
overheat, cracking or burning.
In case of such abnormalities as discoloration and a rise in temperature when the battery is
used, charged or stored, please stop use and replace it.
Keep the batteries of dampness for fear of overheat, smoking or corrosion.
1.2.3 Whole System Operating Instructions
Don’t dismantle or refit the machine on your own. Our company is not responsible for any
damage due to any illegal operation.
Don’t use the terminal near an electronic device with weak signals or high precision, or the
radio wave interference might cause wrong operation on the electronic device or other
problems
。
Don’t put the terminal too close to such magnetic objects as a magnetic card, or the radiation
