- 2 -
- 4 -
Before operating this product please read the instructions completely
Avant d'utiliser ce produit, faveur lisez les instruciones complètement
Antes de utilizar este producto, favor lea las instruciones por completo/
English page 1/
Spanish page 5/French page 8
CDP3107
Instruction Manual
CD Player with 60- second Anti-skip Protection
Manuel d'Instruciones
Manual de Instruciones/
TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS UNIT TO RAIN OR MOISTURE.
This symbol is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the
appliance.
Any use of the controls or an adjustment to the procedures other than those specified herein may result in hazardous radiation.
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. however, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
This product utilizes a Class 1 laser to read Compact Discs. This laser Compact Disc Player is equipped with safety switches to avoid exposure when the CD
door is open and the safety interlocks are defeated. Invisible laser radiation is present when the CD Player's lid is open and the system's interlock has failed or
been defeated. It is very important that you avoid direct exposure to the laser beam at all times. Please do not attempt to defeat or bypass the safety switches.
Receiver complies with
Part 15 of FCC rules when manufactured.
•
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). THERE ARE NO USER-SERVICEABLE PARTS INSIDE. PLEASE REFER ANY
SERVICING TO QUALIFIED SERVICE PERSONNEL.
WARNING:
NOTE:
2 x "AA" Alkaline Batteries
OPEN
VOLUME
PLAY/PAUSE
PLAY/PAUSE
PLAY/PAUSE
SKIP/SEARCH -
SKIP/SEARC -
SKIP/
SKIP/
STOP
I5
0I
02
00 00
00 00
00 00
:
:
:
REPEAT 1 TRACK
MODE
MODE
NORMAL PLAY
RANDOM PLAY
0I
:
0I
:
REPEAT ONE
0I
0I 25
0I 25
0I 25
:
REPEAT ALL TRACK
MODE
MODE
REPEAT
ALL
0I
:
0I 25
Warnings and Precautions
Special Note
When placing your unit on a lacquered or natural finish, protect your furniture with a cloth or other protective material.
PLAY/PAUSE BUTTON
VOLUME CONTROL
STOP BUTTON
4.5V DC IN JACK
HEADPHONE JACK
OPEN BUTTON
PROGRAM BUTTON
SKIP/SEARCH -
SKIP/
MODE BUTTON
BASS BOOSTSWITCH
MODE
INTRO PLAY
0I
:
0I 25
Features
Power Source
- 3 -
- 1 -
TroubleShooting
PROBLEM
SOLUTION
POSSIBLE CAUSE
Service Information
GPX Consumer Service
2116 Carr St. St.louis , MO 63106
(314)621-2881
Visit us at www.gpx.com
Email Consumer Services at
prodinfo@gpx.com
No sound is heard.
GENERAL
Press the PLAY/PAUSE Button.
VOLUME Control is set to minimum.
Adjust the VOLUME Control.
Disc is inserted but tracks are
not displayed.
CD PLAYER
Disc is inserted upside-down.
Insert disc correctly (label up).
Disc is seriously warped.
U s e a n e w d i s c
Moisture has formed inside the CD deck.
Take out the CD and leave the CD player open for
about an hour to dry.
Disc is dirty.
Wipe clean with soft Cloth.
Certains sections of the disc are not
played normally.
Disc is scratched.
Skip over scratched sections; otherwise, replace
the disc.
Disc is dirty.
Wipe clean with soft cloth.
Disc is scratched.
Use a new disc.
Power is not on.
Replace the batteries.
Programming your CD tracks
In stop mode:
1. Press the PROG button and the track numbers
will start flashing.
2. Press SKIP/SEARCH - or SKIP/ to find
the desired track you would like.
3. Press PROG button again and it will save the track
you picked as the first track on your progam.
Repeat steps 2-3 to program up to 20 tracks.
4. Press PLAY/PAUSE button to start playing your
program.
5. To cancel program press STOP twice
or press the OPEN button.
Note:
Note:
You can edit the programmed tracks or add additional
programmed tracks by following the steps above.
Power Source
Connect the AC plug to a 120v AC, 60Hz wall
outlet and then insert pin into DC jack.
Go to
to purchase optional AC
adaptor under accessories for this product.
www.gpx.com
Using AC Adaptor
Battery Power
Use (2) “AA” size batteries (Not included)
to power the unit:
1. Remove battery door by pushing down on
tab.
2. Insert two (2) “AA” batteries as shown.
Alkaline batteries are recommended for the
longest playing time.
3. Replace battery door.
WARNING:
Danger of explosion if batteries are incorrectly
replaced. Replace only with the same or
equivalent type.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or
rechargeable (nickel-cadmium) batteries.
• Replace the batteries when the sound becomes
unstable or cannot be heard.
• When you are not going to use your unit for a
long time, remove the batteries to prevent
damage from battery leakage and corrosion.
RND
INTRO
STOP
1
OR
3
2
PROG
PROG
4
5
PLAY/PAUSE
04
00 00
PROG
:
00
0I
PROG
I4
0I
PROG
00
00
0I
0I
02
0I
DBBS
PROG
x2
PROG
PROG
Listening to a CD
Using the headphones
1. Insert the pin side into the headphone jack.
1. Push the OPEN button and lift the lid up.
2. Place the CD in the unit label side up, close the
lid and press PLAY/PAUSE.
3. Use the VOLUME SWITCH on the side of the
unit to adjust the volume.
4. When searching for a song press the
SKIP/ or SKIP/SEARCH - to locate the
song. To fast forward through a song press and
hold the SKIP/SEARCH buttons and release
where desired.
5. Press the PLAY/PAUSE button to pause the music,
press it again to continue playing.
6. Use BASSBOOST switch to enhance the bass
sound.
7. When done listening press STOP.
Note:
This unit plays CD, CD-R and CD-RW discs.
CD-R/CD-RW discs must first be finalized.
Note:
CAUTION:
Set the Volume to a low level before putting on the
headphones. Gradually adjust the Volume to a
comfortable listening level.
Please do not play the
volume too loudly for extended periods of time.
Repeat and Random functions
1. Pressing the MODE button shuffles through
REPEAT ONE, REPEAT ALL,
and
RANDOM.
INTRO,
NOTE:
NOTE:
NOTE:
The REPEAT modes can be used while playing
programmed tracks see the "Program Play"
section for details on programming tracks.
If RANDOM Play is selected while in Play Mode, the
"RND" Indicator will flash in the LCD. Random
Play will not begin until the next track is selected
using the SKIP/SEARCH Buttons.
If Intro Play is selected while in Play Mode, the
"INTRO" Indicator will flash in the LCD and Intro
Play will not begin until the next track is selected
using the SKIP/SEARCH Buttons.
Listening to a CD
Using the headphones
1. Insert the pin side into the headphone jack.
1. Push the OPEN button and lift the lid up.
2. Place the CD in the unit label side up, close the
lid and press PLAY/PAUSE.
3. Use the VOLUME SWITCH on the side of the
unit to adjust the volume.
4. When searching for a song press the
SKIP/ or SKIP/SEARCH - to locate the
song. To fast forward through a song press and
hold the SKIP/SEARCH buttons and release
where desired.
5. Press the PLAY/PAUSE button to pause the music,
press it again to continue playing.
6. Use BASSBOOST switch to enhance the bass
sound.
7. When done listening press STOP.
Note:
This unit plays CD, CD-R and CD-RW discs.
CD-R/CD-RW discs must first be finalized.
Note:
Repeat and Random functions
1. Pressing the MODE button shuffles through
REPEAT ONE, REPEAT ALL,
and
RANDOM.
INTRO,
NOTE:
NOTE:
NOTE:
The REPEAT modes can be used while playing
programmed tracks see the "Program Play"
section for details on programming tracks.
If RANDOM Play is selected while in Play Mode, the
"RND" Indicator will flash in the LCD. Random
Play will not begin until the next track is selected
using the SKIP/SEARCH Buttons.
If Intro Play is selected while in Play Mode, the
"INTRO" Indicator will flash in the LCD and Intro
Play will not begin until the next track is selected
using the SKIP/SEARCH Buttons.
