71
Leveling Foot Adjustment
Loosen the top nut on the leveling foot
with the 17 mm Open-end wrench.
a
Turn the bottom nut with the 14 mm Open-
end wrench until the desired height is set.
Turn counter-clockwise to lower the frame.
Turn clockwise to raise the frame.
b
Tighten the top nut with the 17 mm Open-
end wrench until it is firm against the
frame leg.
c
Task 9 - Leveling the Frame (continued)
Move the machine to the left side of
the frame and place the machine in the
middle of the bottom carriage. Let go of
the machine to see if it rolls and in which
direction.
3
• If the machine rolls towards the middle of
the frame, raise the middle feet.
• If it rolls towards the front, raise the front
foot.
• If it rolls towards the rear, raise the rear
foot.
Note
: Due to the weight of the
machine, some slight movement is
normal. The goal is to prevent the
machine from rolling across the frame.
After lowering the frame, make sure both
channel locks are open so the machine and
bottom carriage can roll freely.
2
Crib Assembly Part Three
Summary of Contents for Q-Zone Queen
