16
Step 3 - Installing the Tracks
Parts & Tools Needed:
Slide a
track connector
into one of the
track supports
so that it passes the first
two holes, but not the third.
1
2
Instructions
The frame tracks allow the quilting machine to move across the frame. To install the frame tracks,
take the following steps:
•
Track Supports (x4)
(Removed from table sections in Step 2)
•
Connector Bolts (x16)
(Removed from table sections in Step 2)
Set Screw
M6 x 6 mm (x8)
Track Support
Connector (x2)
Long Plastic
Track (x4)
Allen Wrench 3 mm
Full Frame Assembly
4 mm
T-Handle Allen
Wrench 4 mm
(Box 1: Inner Box)
(Box 2)
(Box 1: Inner Box)
(Box 1: Inner Box)
(Box 1: Inner Box)
Screw two
M6 x 6 mm set screws
into
the track support with the 3 mm Allen
wrench. Tighten until the connector is held
firmly in place.
1
2
3
Track Support
Track Connector
M6 x 6 mm Set
Screws (x2)
Bottom Carriage
(Box 4)