GRACE EASY Manual
Page | 81
The battery goes into protection mode when the GRACE EASY is not used for two
months at a time or when the battery charge was used up and was not re-charged
in the week that followed.
The battery is inactive in protection mode. The only way to re-activate the battery is
through a full charging cycle.
When the battery is in protection mode, the lights do not work. Driving the bike
without working lights may be prohibited in some countries.
2.3.
Adjusting the saddle
To adjust the height of the saddle, undo the SW4
hexagon socket in the clamp on the saddle post.
Adjust the height of the seat to your height by placing
your heel on the pedal when the crank is at the
lowest point. Your leg should be almost fully
extended.
If you pull out the seat post too far, the seat tube may no longer be able to support
the seat post sufficiently. The seat post may come undone while riding or it may
damage or break off the seat tube. Danger of injury or accident!
Do not extend the seat post further than the minimum depth mark of 10 cm (3.94
in).
If you are not able to lower the saddle height enough, because the license plate
holder touches the frame, it is possible to buy a special license plate holder at your
GRACE dealer. This new holder allows you to lower the seatpost as far as possible.
There is a risk that the cable for the rear light is damaged when removing the seat
post. Therefore, remove the saddle post slowly and undo the plug between the seat
post and seat tube once it becomes visible.
Tighten the screw on the saddle post clamp (see torque table).
