GRACE EASY Manual
Page | 109
5.6.
Adjusting the belt guide
The belt guide prevents the drive belt jumping on the rear belt pulley or prevents it from
being able to slip from the pulley.
The gap “A” between the belt guide and the back of
the belt should lie between 1 - 1.5 mm (0.04 - 0.06
in).
To adjust the gap undo the screw with a hexagon
socket SW5 (0.2 in) and move the belt guide in the
elongated bore.
Tighten the screw again with a hexagon socket SW5
(0.2 in) (see torque table).
5.7.
The drive chain (EASY 1x10)
The chain should always be metallically clean and have a sufficient coating of lubricant.
If the chain is dry (without lubrication) or dirty, clean it with a clean or slightly oily cloth and
then coat it with a bicycle chain oil that is commercially available and leave it overnight.
Remove any excess oil the following day with a cloth.
5.8.
Switching gears (EASY 1x10)
Please consult the attached manual from the
manufacturer, SRAM for information on the gearshift
adjustment.