21
Parts & Tools Needed:
Instructions
The encoders monitor the position of the machine over the frame, allowing for regulated stitching.
The upper encoder is installed on the outward-facing, left-rear wheel of the machine. Please take the
following steps:
Installing the Upper Encoder
Left Rear Wheel
2.5 mm
T-handle Allen
Wrench 2.5 mm
4 mm
T-handle Allen
Wrench 4 mm
Upper Encoder
(silver spring)
Wheel Screw
1.
Use the 4 mm Allen wrench to remove the
left rear wheel
from the machine.
The
wheel screw
will not be needed
again, and can be stored with the packaging
materials.
1
2. Slide the wheel onto the upper encoder
screw
so that the
wheel hub
faces away
from the encoder.
Wheel Hub
Encoder Screw
3
Out-of-the-Box Assembly
1. Loosen the
lock collar screw
(shown in
blue) on the upper encoder with the 2.5
mm Allen wrench until the lock collar
turns freely.
Lock Collar
2
Note: Depending on the encoder, this step
may require the 2.0 mm Allen wrench.
