24
Out-of-the-Box Assembly
2. Slide the
wheel
onto the
encoder screw
,
followed by the
wheel spacer
.
O-Ring
Encoder Screw
Wheel
Spacer
Wheel
Hub
Encoder
Screw
For dual-wheel carriages, slide the wheel
onto the
encoder screw
with the
wheel
hub facing away from the encoder.
Lock Collar Screw
3. Place the encoder screw into the left rear
wheel hole on the carriage so the O-ring is
between the rear wheels.
4.
Turn the encoder lock collar (shown in
blue) to point up. Then tighten the lock
collar screw
with the 2.5 mm Allen wrench.
Note: Depending on the encoder model, this
step may require the 2.0 mm Allen wrench.
Encoder
Port
5. Plug the encoder cable into one of the
encoder ports on the back of the machine.
6. To prevent the long encoder cable from
catching the carriage, use the adhesive zip
tie mount and zip tie to fasten the cable to
the side of the bottom carriage.
4
5
6
7
8
Installing the Lower Encoder (Continued)
Zip Tie
Mount