60
Adjusting the Bobbin Cam
Parts & Tools Needed:
• 1.5 mm Allen Wrench (not included)
Point toward bobbin to
decrease fill.
Point away from bobbin
to increase fill.
4.
Point the set screw toward the bobbin to decrease the amount the bobbin will fill before the
winder shuts off. Point the set screw away from the bobbin to increase the fill amount.
4
Instructions
The machine’s
bobbin cam is set so the bobbin will wind completely before the winder shuts off. To
change how much the bobbin fills before the winding stops, take the following steps:
1.
Power off the machine.
2.
Place an empty bobbin onto the bobbin stand and flip the bobbin cam toward the bobbin. This
will help estimate how far to adjust the bobbin cam.
1
2
3. Loosen the
set screw
on the bobbin cam with a 1.5 mm Allen wrench until the top of the
bobbin cam twists freely.
Set Screw
3
5. After choosing the desired distance, tighten the set screw with a 1.5 mm Allen wrench.
5
Maintaining the Machine
