pg. 6
1-7: Place a Table Angle Support at a 45
degree angle on the front top corners and
back top corners of the frame on the outside.
Line up the holes on the angle support with
one hole on the front side of the leg tube,
and one hole on the table support. Screw a
M6 x 10mm Connector Bolt into each hole, as
shown in Fig. 1-2.
Note: Attach the Table Angle Support to the
middle leg for the crib size, as shown in Fig
1-3.
Step 2: Table Brace Assembly
Parts Needed:
-Table Brace (4)
-M5 x 10mm SCHCS (8)
2-1: Attach each Table Brace to the Table
Supports by aligning the holes on the two
ends of the table brace with the flat side
facing up, screwing in the (8)-M5 x 10mm
SCHCS, as shown in Fig. 2.
Perform the same step with table braces for
crib size, only 2 table braces will be used on a
crib size frame, as shown in Fig. 2-1.
Note: Be sure the table braces are parallel to the legs.
Table Brace
M5 x 10mm
SCHCS
Fig.2
Fig.1-3
Fig.2-1
Table Angle
Support
M6 x 10mm
Connector Bolt
Fig.1-2
Summary of Contents for SR2+
Page 19: ...pg 19 ...
