Grace SR2+, Assembly Instructions Manual

pg. 8

4-5: Repeat through Steps 4-1 to 4-3 to assemble the other side of the the 

track on crib size frame as well, see Fig. 4-3.

4-6: Tighten the track along the front of the frame, making sure the track 

supports are even with the front edge of the frame.

Note: Leave the rear track loose at this time.

Step 5: Rail Holder Bracket 

Assembly

Parts Needed:

-M6 Nylock Nut (4)

-M6 Flat Washer (4)

-Rail Holder Bracket Left (2)

-Rail Holder Bracket Right(2)

-Frame End Connector (4)

Note: The Left and Right Rail Holder 

Brackets are attached at the two long 

slots in the frame ends, the heights 

and distances between the rail holder 

brackets can be adjusted as needed. 

5-1: Assemble a Frame End Connector 

onto the Frame End Left so that the 

screw hole in the middle of the Frame 

End Connector is in line with the slot in 

the middle of the Frame End Left. 
5-2: Place the Rail Holder Bracket Left 

onto the Frame End Left.  Make sure 

that the bracket is placed in the right 

direction, see Fig. 5. 
5-3: Place a M6 Flat Washer and a M6 

Nylock Nut on the protruding bolt on the inside of the Frame End, see Fig. 5.
5-4: 

Assemble the other Rail Holder Bracket Right onto the Frame End Left the same way as first one 

except locating the bracket at the end of the frame end, where there is a screw hole, see Fig. 5.
5-5: Assemble the (2) Rail Holder Bracket Right on the other side of the 

frame by repeating the above steps once again. See Fig. 5-1. Assembly steps 

are the same for crib size frame, see Fig. 5-2.

Note: Be sure that all rail holder brackets are facing the correct direction as 

shown in the picture. 

Fig.5-2

Fig.4-3

Rail Holder

Bracket 

Left 

 M6 Nylock 

Nut

M6 Flat 

Washer

Fig.5

M6 Nylock 

Nut

M6 Flat 

Washer

Rail 

Holder

Bracket 

Right 

Fig.5-1